1. Lay poly, protecting on surface for assembly

2. Position open end up, on poly being careful not to scratch.

3. Lay out wires, (wrapped in poly), and note 45° angle on one end and hook end on opposite end.

4. Clip hook end over flanges on mirror.

5. Clip 2nd wire on opposite side of mirror in same manner.

6. Insert wash between opposite wires at end with 45° angle. Gently squeeze mirror at wire ends to assist in hanging washer between wires.

7. Assemble remaining wires in same manner making sure all wires are equal distance apart at flange area and clip 45° angle end into washer between wires.

Note:

	18" Uses 4 Wires	26" Uses 6 Wires
	32" Uses 6 Wires	36" Uses 8 Wires
	48" Uses 8 Wires

8. Mirror can now be hung with any cord, wire or chain. Attach cord to center washer. To level mirror attack second cord to lowest end of mirror at inverted U area of wire and tie other end of leveling cord to midpoint of center cord.